Welcome to see SENFENG new web

Since 2004
Professional Laser Cutting Machine Manufacturer

HomeFAQ common problems for laser cutting engraving system

common problems for laser cutting engraving system

2014-08-07 14:34 

If the Boot but laser cutting machine is not start
1.Check whether the machine electricity is ok
2.check the main parameters is correct
1.check the electrical wires again
2.set up the parameters refer by software instructions
If Working without laser
1.Check wether the optical path skewing
2.Line problem
Method :
1.Adjust the light path
2.Judgment with plug the rays into the power of the signal terminal

workshop in senfeng

The laser on and off at work
1.Check whether the water cycle is ok
2.whether the supply voltage is stabilize
Method :
1.Clean the water tank and water pump,clear the pipe
2.Add voltage stabilize to power supply
Theonline data can’t be disposed
1.whether the communication cable is connected
2.whether the software USB is installed
Method :
1.Shutdown and reconnect the cable
2.Reinstall the software and USB drive

Processing size does not consistent with software set
1.Install the software
2.Adjust action
1.install the original software torecover original parameters
2.sized the working area and trim size .calculate refer to software
The control panel no light
1.Line is loose
Check whether the connecting line is loose from main board to panel
If Boot reset is limited
There is problem of limit switch and signal
Check parameter of software and limit switch setting
If Carving dislocation
1Electrostatic interference
2Drive parts is loose
1.Reconnect ground wire two meters below ground
2.Check if the gear top silk and strap is loose

More information about laser cutting machine , please contact us !

I want to place an order

  • Name
  • Name
  • Tel
  • Email
  • Country
  • Msg
  • *Code
    Verification Code

Users' hot comments